User's Manual

activity is detected on the "Priority" channel, the radio will move to that
channel for as long as it remains active. To enter look back mode, press and
hold the scan button, first button located beneath the PTT button. PS will be
shown in the display and the LED will flash green.
NOTE: Look Back requires that the radio leave the active channel for a
fraction of a second (at regular intervals) to check the priority channel for
activity. Depending upon how the radio is programmed (scan speed, etc.) this
may or may not be noticeable as "breaks" on the active channel for that same
fraction of a second. A transmission will be made on the selected channel at
all times.
· Scan Channel Delete: To temporarily delete a channel from the scan list,
simply press the monitor button while scanning and stopped on the channel to
be deleted. This will remove that channel from the scan list until the channel is
changed or the radio's power is reset. When power is restored or the scan list
channel position is again selected, the original Dealer programmed scan list
will be activated.
· CTCSS/DCS/SELCALL Scanning: The SL-200 can be programmed by
your Dealer to scan for tone. This will help block out unwanted calls.
· Normal Scan TX: Allows a transmission only after a call is received,
depending on the programmed scan delay time. After the scan resumes, and a
transmission is made, the radio will sound an alarm (two beeps) , display_h
and will not allow a transmission.
· Priority Scan TX: Allows a transmission after a call is received depending
on programmed scan delay time. The transmission will be made on the
channel that the call was received. After the scan resumes, if a transmission is
made, the radio will transmit on the programmed priority channel.
· Priority Only TX:
Allows a transmission on the priority channel when
scanning and not stopped on an active channel. It can also be programmed to
( Remove) will always transmit on the priority channel if scanning
or stopped on an active channel.