User's Manual

· Receive Only Scan: This allows only reception. If a transmission is made at
any time, the radio will sound an alarm (two beeps) ,, display r0 and will not
allow the transmission.
Scan List Edit
You as a user can edit your radio’s scan list and priority scan channel at
anytime form your radios original program.
Your radio may have been programmed for channel only scan operation or
channel Group scan operation this operation was determined by your Dealer
programming. Please note, if your radio has been programmed for channel
only scan you will not be able to edit your scan list. You will be able to edit
yourpriority channel.
Channel Only Edit: To edit the scan list in a radio programmed for channel
only scan, turn radio off, press and hold scan button, first button beneath the
PTT button. While holding scan button turn radio on, release the scan button
after the first red flash of the LED and SE is shown in the display. Upon
release of the scan button the first channel number will be displayed. If
channel number is flashing that channel is already included in the scan list. If
channel number is solid that channel is not included in the scan list To add or
delete the selected channel to or from the scan list press and release the
monitor button, second button located beneath the PTT button. The selected
channel will flash if selected channel was added to the scan list or the selected
channel will be solid if the selected channel was deleted from the scan list. To
edit other channels press the buttons to select the desired channels to be added
or deleted from the scan list and repeat the process. Upon completion of
adding or deleting channels to or from you r scan list press and release the
scan button, first button located below the PTT button, your new scan list
should be entered at this time.
( Remove entire statement)
Channel Group Edit: To edit the Group scan list in a radio programmed for
channel group scan, turn radio off, press and hold scan button, first button
beneath the PTT button. While holding scan button turn radio
on, release the scan button after the first red flash of the LED and SE is shown
in the display. Upon release of the scan button the first group number will be
displayed. If you do not wish to edit the group you have selected press the