User's Manual

The Radio shall support the encoding and decoding of 83 normal and inverted DCS data.

• TX operation : Upon the pressing of PTT, the radio shall encode the programmed DCS bit pattern for the

selected channel and enter TX mode. The data shall last for the duration of the transmission.

• End of TX operation : Upon leaving TX mode, the radio may employ squelch tail elimination. This shall

be done by sending a turn off code.

•

RX operation : The radio shall decode the incoming data stream to determine if there is a match with the

pre-programmed DCS data. If the DCS data is properly decoded, the radio shall enter correct call state

from busy state. When the proper DCS data is longer being decoded, the radio shall enter busy state from

correct call state.

Programming & Cloning

The S

P-6102 radios require the programming cable. With the 9 pin connector installed on the computer,

take the other end of the programming cable and insert it in the receptacle located on the Mic Jack of upper

position on the radio.

Reading

(1) Ensure that radio’s power switch is in the “OFF” position.

(2) Connect the programming cable through mic jack.

(3) Place the radio in the pc program mode by holding the radio’s monitor switch and then turning radio

power switch to the “ON” position. Release the monitor switch on the first led flash(In this time, the

radio display “PC PROGRAM” message on LCD).

(4) Press the Read button on PC Program. The LED shall glow red and programming will be start.

Then display “READING” on LCD.

(5) After programming, the radio display "COMPLETED" message on LCD.

Writing

(1) Ensure that radio’s power switch is in the “OFF” position.

(2) Connect the programming cable through mic jack.

(3) Place the radio in the pc program mode by holding the radio’s monitor switch and then turning radio

power switch to the “ON” position. Release the monitor switch on the first led flash(In this time, the

radio display “PC PROGRAM” message on LCD).

(4) Press the Write button on PC Program. The LED shall glow red and programming will be start.

Then display “WRITING” on LCD.

(4) After programming, the radio display "COMPLETED" message on LCD.

Cloning

The S

P-6102 radios require the cloning cable. The frequencies and functions can be programmed from

radio to radio by using a cloning cable.

(1) Ensure that both radio’s power switches are in the “OFF” position.

(2) Place the master radio(the radio which already has desired program information in the EEPROM) in

the data master mode by holding the radio’s monitor switch and then turning radio power switch to the

“ON” position(the yellow LED on the radio flashes). Release the monitor switch on the thirth led

flash(In this time, the radio display “MASTER” message on LCD).

(3) Place the slave radio(the radio which is not programmed, or has program information that will be

revised) into data slave mode by holding the radio’s monitor switch and then turning the radio power