User's Manual

12
switch to the “ON” position(the yellow LED on the radio flashes). Release the monitor switch on the
second led flash(In this time, the radio display “SLAVE” message on LCD).
(4) Connect the cloning cable through mic jack.
(5) Press the slave radio’s monitor switch. The LED shall glow green.
(6) Press the master radio’s monitor switch. The LED shall glow red. And Cloning will start.
(7) After cloning, the slave radio display "COMPLETED" message, and the master radio display
“MASTER” message on LCD. Press monitor switch, and then the radio will repeat step 6).
(8) For cloning other radios, repeat step 3) through 7).
Service Information
Service
Do not tamper with internal adjustments. Damage to the equipment and/or improper operation may result.
There are no user serviceable items inside the radio.
It is recommended that you return your radio to a qualified Maxon Dealer for any service or repairs.
Recycling/Disposal of Batteries
The battery should be recycled at the end of its useful life. Under various state or local laws, such batteries
must be recycled or disposed of properly and cannot be dumped in landfills or incinerators.
For jurther information on how to safely dispose of four used batteries ,contact your reseller.
Maintenance
Your S
P-6102 Radio is designed to be maintenance free. To keep your radio in good working condition:
Clean external surfaces with a clean cloth dampened in a solution of dishwasher detergent diluted in water.
Apply the solution sparingly to avoid any moisture leaking into cracks and crevices. Do not submerge the
radio. Use a non-metallic brush to dislodge stubborn particles, if necessary. Dry the surface thoroughly
with a soft, lint free cloth.
DO NOT use solvents or spirits for cleaning - they may permanently damage the housing.
Clean the battery contacts on the back of the radio with a lint free cloth to remove dirt, grease, or other
foreign material that may impede good electrical contact.
Limited Warranty
Maxon shall have no obligation to make repairs or to cause replacement required which result from normal
wear and tear or necessitated in whole or in part by catastrophe, fault or negligence of the user, improper or
unauthorized alterations, repairs to the Product, use of the Product in a manner for which it was not
designed, or by causes external to the Product. This warranty is void if the serial number is altered, defaced
or removed.
Maxon's sole obligation hereunder shall be to repair or replace the Product covered in the above warranty.