user manual

HSDPA Standard At Commands Page 60 of 60 Version 1.2
<password>,
<username>
 0 None
 1 PAP
 2 CHAP
additional parameters are required, as
follows:
 0 – Neither username nor password
accepted
 1 – Username and password
accepted
 2 – Only password (secret)
accepted
Query command, i.e., $QCPDPP?,
does not display password values and
only displays username for PAP
authentication.
$QCPWRDN used to power down the ME
Returns OK and then shuts down the
phone
Supported
$QCDGEN=<
cid>,<data
length>
Generates data over
+CGACT activated PDP
context
 <cid> – 1 to 16
 <data length> – 21 to 2^32
Supported only during PDP context
activation by +CGACT
Supported
$QCSLOT=
<slot>
set SIM card slot commands
will operate on
Slot other than 1 only available if
FEATURE_DUAL_SLOTS enabled
Supported
$QCPDPLT=<
enable>
Enable/disable tolerance to
long delays in PDP call setup
Supported
$QCPINSTAT
?
sends the ME the status of
all PINs for all cards
Statuses listed in order: SIM PIN, PH
FSIM PIN, NET PIN, NETSUB PIN,
SP PIN, CORP PIN, SIM PIN2
Supported