User manual

11921 Slauson Ave. Santa Fe Springs, CA. 90670 [phone] FAX [phone]
42
CHECK
CLEARANCE
HERE
CHECK
CLEARANCE
HERE
NOTE: To reinstall the pads, use the same shim setup that was removed with the
pads. Clearance between pad and guide in the column should be a as
close to .00” as possble.
NOTE: To have minimum clearance between column, pads and runner, follow this
procedure. Push pad against runner and column, then slide upper pad up,
and lower pad down, until there is zero clearance. Then use closest set of
holes to tighten pad on runners.
32. Bolt the upper and lower pad
assemblies and shims (FIGS.
42-1A & 42-1B) to runner.
UPPER PAD
FIG. 42-1A
LOCK WASHER
(2 PLACES)
BOLT
(2 PLACES)
BOLT
(2 PLACES)
LOWER PAD
FIG. 42-1B
FIG. 42-1
UPPER PAD
RUNNER
RUNNER
COLUMN
COLUMN
LOWER PAD
LOCK WASHER
RUNNER REPLACEMENT - Continued
REPLACING PARTS