User manual

11921 Slauson Ave. Santa Fe Springs, CA. 90670 [phone] FAX [phone]
48
43. Reattach chain arm to LH runner. Then,
bolt on the pin collar to secure chain arm
(FIG. 48-2). Repeat for
RH runner.
42. Lower (DOWN) platform on jack stands
(FIG. 48-1) so inboard edge is 4” below
ramp edge.
41. Raise the platform (UP) slightly and
remove 2 jack stands near the inboard
edge (FIG. 48-1).
44. If necessary, do the BLEEDING
HYDRAULIC FLUID procedure in
this manual.
RAMP
FIG. 48-1
FIG. 48-2
JACK STAND
(2ND JACK STAND
NOT SHOWN)
PLATFORM
4”
INBOARD
EDGE
RAMP
EDGE
CHAIN
ARM
RUNNER
COVER
BOLT
PIN COLLAR
LOCK NUT
REPLACING PARTS
RUNNER REPLACEMENT - Continued