9.5.2

432 • CHAPTER 7
OBJECTS MENU • DEFORMERS • 433
Attribute manager settings
Object Properties
Strength
Denes the state of the shatter deformation. 0% is the start of the shatter effect (no shattering),
100% is the end (pieces shattered and lying on the ground). To change this value interactively, drag
the orange handle in the viewport.
Angle Speed
Denes the angle through which each polygon rotates during the entire shatter deformation.
End Size
Denes the relative size of each polygon at the end of the shatter deformation (when Strength is
100%). If the value is set to 1, the polygons will remain the same size throughout the deformation. If
the value is set to 0, the polygons will disappear by the end of the shatter effect. If the value is 2, the
polygons will double in size.
Randomness
Denes the percentage by which the individual polygon speeds may vary from the perfect, uniform
value.
The Shatter object does not support vertex maps.
Shear
This deformer shears an object. Drag the orange handle on the deformer’s top surface to control the
shear deformation interactively in the viewport.