9.5.2

584 • CHAPTER 10
STRUCTURE MENU • 585
Above, you can see the problem that arises when starting with an Inner Offset value that is set too
high. To remedy, set Inner Offset to a lower value.
Var (Inner Offset)
Var 0%. Var 60%.
Varies the inner offset. This option will have no effect if Preserve Groups (see below) is enabled.
0% - No deviation from the offset value
60% - Edges of selected polygons are inwardly beveled between 40% and 100%
of the Inner Offset.
100% - Edges of selected polygons are inwardly beveled between 0% and 100%
of the Inner Offset.
180% - Edges of selected polygons are beveled between -80% (outward) and
100% (inward) of the Inner Offset.
Subdivision
Subdivision set
to 0.
Subdivision set to 3.