Manualshelf

9.5.2

ManualsBrandsMaxon ManualsApplicationsCinema 4D
681682683684685686687688689690
Table Of Contents
650 • CHAPTER 12
The lines get thicker when I scale the SWF document. How do I get the lines to stay the same
thickness?
Set the line width to 0 (hairline). The player will then always display a thin, 1-pixel line, no matter how
much the SWF document is scaled.
Sometimes I can’t see planes and single polygons from the side. How can I make them show
up as lines?
In the FlashEx dialog, on the General tab, set Polygons to All. Now all polygons will be visible regardless
of whether they point at the camera.
I’m getting errors in the FlashPlayer, such as missing lls or incorrect lls.
Try the following:
Optimize the objects — remove defective polygons.
Use as few polygons as possible. Simplify the objects using the Polygon
Reduction tool.
If you are exporting HyperNURBS objects, reduce the number of subdivisions
(the exporter uses the Subdivision Renderer value).
SpaceMouse
This command is available only if you are using Windows. The SpaceMouse is an input device especially
designed for 3D applications. Use this command to access controls that enable you to ne-tune this
device.