User manual

Toolbox 32 User Manual 1.47d www.cse-semaphore.com/mykingfisher
Page
269
#YSTAT.
cc
RTU status register
Ch1 Please see Chs 6-8 Read
Ch2 1 = CPU in slave mode, 0 = CPU in master mode Read
Ch3 1 = I/O scanning enabled, 0 = IO scanning disabled Read
Ch4 1 = logic enabled, 0 = logic disabled Read
Ch5 1 = RTU in program mode (IO and logic scanning disabled)
0 = RTU in run mode
Read
Ch1,
Ch6-8
CPU / RTU type Read
Ch8 Ch7 Ch6 Ch1 Description
0 0 0 0 CP-1
0 0 0 1 SBX-2
0 0 1 0 PC-1
0 0 1 1 PC-1
0 1 0 0 CP-20/21
0 1 1 0 CP-10/11
1 0 1 0 ERS
1 0 1 1 Micro-3
1 1 0 0 LP-1/2/3
1 1 0 1 Micro-4
Ch12-
14
RAM size Read
LP-1/2/3, PC-1, CP-1, SBX-2 CP-10/11, CP-20/21
Ch12 1 = RAM >= 128 K
0 = RAM < 128 K
1 = RAM >= 512 K
0 = RAM < 512 K
Ch13 1 = RAM >= 256 K
0 = RAM < 256 K
1 = RAM >= 1024 K
0 = RAM < 1024 K
Ch14 1 = RAM >= 512 K
0 = RAM < 512 K
1 = RAM >= 2048 K
0 = RAM < 2048 K
Ch15 LP-1/2/3 Only: 1 = extended FLASH memory, 0 = No extended
FLASH memory
Read
Ch16 1 = RAM Fault, 0= RAM OK Read
#YSYS.ENABLE
1= First scan of ladder after downloading ladder logic or after a Toolbox
Enable Logic Processing command is received.
Read
#YSYS.SCAN1
1 = First scan of ladder logic after a warm start, a power reset or after
downloading the SDB file. Not activated when waking up from sleep
mode or after downloading ladder logic.
Read
#YSYS.WARMST
1 = Warm reset CPU (Setting this bit will warm start the RTU).
0 = Normal CPU operation
Read/Write