User manual

User Manual PM200
Page 15
English
1. Select the Priority Group
Each Scan Group displays “xx_nnn” ‘xx’ means the current Group and ‘nnn’ means the
channel. To activate P scan list editing for selected Priority group, press the P1 button. You can
change the Priority Group Number by using the up or down button.
2. Adding or Deleting to P Scan List
If each Channel is included in P Scan Editable List, the Channel Number would display “Pscan
Icon. To add or delete channel from P Scan Editable List, use P2 button.
Basic programmable features
Function Keys
There are six push-buttons on the face of the PM200/250; Up / Down ( ), P1, P2, P3 and ▼▲
Emergency, below are the default programming settings.
Up/Down Keys ( )▼▲
These buttons allow the operator to scroll up/down through the available channels. A short press-
and-release of this button will increase/decrease the channel number. A press-and-hold will scroll
through the channel numbers.
Select pre-programmed Selcall mode via (P1-P3). Use to select the correct selcall function. ▼▲
Basic Programmable Features
Select pre-programmed DTMF mode via (P1-P3). Use to select the correct DTMF number.
Select pre-programmed SMS mode via (P1-P3). Use to select the correct SMS number. ▼▲
Programmable Function Keys
The following functions can be assigned to [P1] [P2] [P3] programmable function keys. These are
located on the bottom left of the radio. Each button has a short and long press giving a total of
six button assignments.
Power key
Press to toggle the transmit Output power between High and Low.
Each channel can be programmed via the PC programmer to be high or low power. The power
can also be changed by the user to high-power output of 25 Watts, and a low-power output of 2
Watt.
Light Key
Press to toggle the
Auto mode, Light Off or Light On mode.
Auto Mode: In this mode the light will automatically come on for 5 seconds after a button press
Off Mode: Light will remain off permanently.
On Mode: Light will remain on permanently.