Service manual

Service Manual SD170E Series
Page 16 of 44
Access to digital and RF boards
Removing top cover
Disassembly and Re-assembly of the Radio
In order to carry out the following Test and
Alignment procedures it will be necessary to gain
access to the inside of the radio.
Care should be exercised when opening up the
radio for maintenance or repair.
In order to
Disassemble the radio, the following procedure
should be used:
1. Unfasten and remove the four mounting screws
located on the top cover of the radio.
Removing the Digital board
2. Remove the four mounting screws located
on the top of the Digital board.
3. Gently lift Digital board away from the
connector on the RF board from the opposite
end to the D-type.
A
A
A
c
c
c
c
c
c
e
e
e
s
s
s
s
s
s
t
t
t
o
o
o
P
P
P
C
C
C
B
B
B
s
s
s