Specifications

11921 Slauson Ave. Santa Fe Springs, CA. 90670 [phone] FAX [phone]
13
PATENTS PENDING
5. Pull out (no threads) Filler Cap (FIG. 12-
2). Fill the Reservoir with Hydraulic Fluid
(TABLE 13-1) to level (“L”) you mea-
sured in step 2. Reinstall Filler Cap (FIG.
12-2).
7. Bolt on the Pump Cover as shown in
FIG. 12-1. Tighten the 5/16”-18 cover
screws until snug.
3. Disconnect the 2 tubes from barbed
fi ttings on the Reservoir (FIG. 13-
1). Unbolt the Reservoir from Pump.
Remove the Reservoir and pour the
used hydraulic fl uid into a drain pan.
6. Stow the Lift. Check the Hydraulic Fluid
level in Reservoir as follows. With Lift-
gate stowed, fl uid level should be 3”
(FIG. 13-2). If needed, add more fl uid
to the Reservoir.
HYDRAULIC FLUID LEVEL
(LH PUMP SHOWN)
FIG. 13-2
4. Bolt the Reservoir on the Pump.
(FIG. 13-1). Reconnect tubes to
barb fi ttings on the Reservoir.
UNBOLTING / BOLTING RESERVOIR
(LH PUMP SHOWN)
FIG. 13-1
TUBE
BARBED
FITTINGS
RESERVOIR
BOLTS
(4 PLACES)
PUMP
TUBE
FILLER
CAP
RESERVOIR
2”
TABLE 13-1
RECOMMENDED HYDRAULIC FLUID
BRAND PART NUMBER
ROSEMEAD THS FLUID 17111
EXXON UNIVIS HVI 26