Specifications

11921 Slauson Ave. Santa Fe Springs, CA. 90670 [phone] FAX [phone]
23
PATENTS PENDING
PLATFORM AT FLOOR LEVEL
(LH SIDE SHOWN)
FIG. 23-1A
INBOARD ROLLSTOP LINES
UP WITH BASE PLATE
FIG. 23-1B
INBOARD
ROLLSTOP
THRESHOLD
PLATE
BASE
PLATE
3. Check if Inboard Rollstop rests on Thresh-
old Plate (FIG. 23-1B) and lines up
with edge of Base Plate approximately as
shown in FIG. 23-1B.
NOTE: When using the Manual Backup
Pump, fi rst make sure the notch-
es are lined up vertically on tip
of the Manual Backup Handle.
Then make sure Handle is fully
engaged with Pump before you
start pumping. See the Opera-
tion Manual for more information
on operating the Manual Backup
Pump.
USING BACKUP PUMP TO FOLD
(LH PUMP SHOWN)
FIG. 23-2
BACKUP PUMP
BACKUP PUMP
HANDLE
CHECKING BIG ROLLER CLEARANCE
(RH SIDE SHOWN)
FIG. 23-3
1/4”-3/8”
BIG
ROLLER
RH
CLOSER ARM
RH LOWER
PARALLEL ARM
4. Start folding Platform with the Backup
Pump (FIG. 23-2) until there is 1/4”-
3/8” clearance between big roller on
RH Closer Arm and the RH Lower
Parallel Arm (FIG. 23-3).