Specifications

11921 Slauson Ave. Santa Fe Springs, CA. 90670 [phone] FAX [phone]
30
PATENTS PENDING
7. Adjust the Inboard Rollstop landing position
on the Threshold Plate, by turning adjustment
screw (FIG. 30-2B and 30-3). Turn screw
1/16 or 1/8 turn after you fold Platform part way
and then unfold it back to fl oor level. At fl oor
level, the Inboard Rollstop should land and line
up as shown in FIG. 30-1B.
TURNING ADJUSTMENT SCREW
FIG. 30-3
CCW FOR MORE INBOARD
ROLLSTOP OVERLAP ON
THRESHOLD PLATE
CW FOR LESS INBOARD
ROLLSTOP OVERLAP ON
THRESHOLD PLATE
FOLD SWITCH ADJUSTMENT SCREW
FIG. 30-2B
LH TOWER
(LIFT WITH LH PUMP)
FIG. 30-2A
ADJUSTMENT
SCREW
PLATFORM AT FLOOR LEVEL
(LH SIDE SHOWN)
FIG. 30-1A
INBOARD ROLLSTOP LINES
UP WITH BASE PLATE
FIG. 30-1B
INBOARD
ROLLSTOP
THRESHOLD
PLATE
BASE
PLATE
6. Check if Inboard Rollstop rests on
Threshold Plate (FIG. 30-1B) and
lines up with edge of Base Plate ap-
proximately as shown in FIG. 30-
1B.
FOLD SWITCH & LOWERING SWITCH ADJUSTMENTS - Continued