Installation Notes
6.3.7 Settings menus
Voltage setting
Enter the voltage setting mode; the system will
display U-12v or U-24V. (This has been set before
leaving the factory and does not need to be
adjusted again).
Note:
Before starting up the device, ensure that the fuel
pump, motor and glow plug are matched to avoid
damage.
PARKING AIR HEATER
31
In the shut-down state, long press the " " key to enter
the menu interface, then press" " or " " to display
VOL, PO, FAN, LA in turn, which respectively represent the
voltage setting, power setting, fan speed setting and
language setting modes. Press "OK" to choose the
selected option.
Language setting
Enter the language setting mode, press " " or
" " to display the 3 languages available, CN
(Chinese), EN (English), or RU (Russian); press
the "OK" key to complete the selection. Exit the
menu interface; the device will return to the
shut-down state.
Enter the fan speed setting mode, and press " " or " "
to adjust the fan speed, which can be set to 5 speeds,
FAN1, FAN2, FAN3, FAN4, or FAN5; press the "OK" key to
complete the selection. After setting is completed, the
corresponding fan speed will be displayed. Exit the fan
speed mode; the device will return to the shut-down
state.
Fan speed setting (Fan mode)
PARKING AIR HEATER
32
6.3.8 Bluetooth pairing (optional)
6.3.9 Parameter display
In operating state, press the "ok" key; the battery voltage,
housing temperature, ambient temperature, fan speed, and
fuel pump speed will be displayed in turn.
Blue-tooth pairing
1) Bluetooth pairing and app operation:
Search for Parking Electric APP on the mobile app store,
follow the prompts to download, install and complete the
registration. It’s applicable to Android system and IOS system.
2) For the first Bluetooth pairing, click "Add Device" on the
mobile APP, select "Heater" (it will scan the Bluetooth module
automatically), and then click "Add".
3) If you want to bind it on another mobile phone, you will need
to cancel the previous binding. Long press the "OK" button on
the panel in the shutdown state. If the heater can be scanned
when you add it to the APP, it means the pairing is successful.
Fig.29
3:11 PM
100%
Parking Heater
Wokring Status
Heating
-19
°C
1
°C
0
°C
40
°C
Shell Temperature
Set Temperature
level 1
Switch
level 2
Level Auto Pump_oil Fan_mode
level 3 level 4 level 5
ON OFF