Installation Manual

2
INCLUDED PARTS:
Carefully remove and identify all the parts from their protective packaging and lay them out in front of you.
Adjustment dials are located on the backside of the motion sensor as shown in the pictures below. Rotate
the motion sensor so you have access to the backside of it. This is the side that is opposite of the front,
denoted by an arrow and the word FRONT on the motion sensor.
INSTALLING/REPLACING THE BATTERIES:
When the batteries run out of power, you can replace the batteries with 3 new C-Cell batteries. Follow the
steps below when replacing the battery.
1. Switch the Dual Head LED Security Spotlight to OFF.
2. Remove the Dual Head LED Security Spotlight from its mounted back.
3. Remove the thumbscrew from the bottom of the back of the Dual Head LED Security Spotlight.
a. Gently press on the button on the top of the back of the Dual Head LED Security Spotlight and
pull the light away from the mounting bracket.
b. If replacing old batteries, carefully remove the old batteries from the battery tray by hand and
three (3) new C-Cell batteries into the battery tray. Ensure that the new batteries are inserted in
the correct +/- polarity orientation as indicated in the battery compartment.
WARNING: BATTERIES INSTALLED INCORRECTLY COULD POTENTIALLY DAMAGE THE UNIT.
4. Press the Dual Head LED Security Spotlight back into the mounted back until the top button clicks
5. Replace the thumb screw in the bottom of the back of the Dual Head LED Security Spotlight.
6. Switch the Dual Head LED Security Spotlight back to AUTO
NOTE: DO NOT DISPOSE OF BATTERIES IN GENERAL HOUSEHOLD TRASH OR INTO A
FIRE SINCE THE BATTERIES MAY EXPLODE. CONSULT YOUR LOCAL REGULATIONS FOR
CORRECT DISPOSAL OF BATTERIES. DO NOT TAKE APART THE BATTERIES SINCE THEY
CONTAIN CORROSIVE CHEMICALS.