Installation Manual

CHOOSING A LOCATION FOR YOUR DUAL HEAD LED SECURITY SPOTLIGHT:

This Dual Head LED Security Spotlight provides safety and security around your home. It is ideal for lighting

up areas where electricity is not available such as porches, driveways, carports outside, garages and

entrance areas.

of 130º at a distance of up to 26 feet when the surrounding temperature is 75°F. The outside temperature

will impact the detection distance. As temperatures get colder the motion sensor will become more sensitive

and the range of the motion sensor will increase.

HOW TO INSTALL YOUR DUAL HEAD LED SECURITY SPOTLIGHT:

TOOLS REQUIRED FOR INSTALL:

You only need a Phillips head screwdriver, however if you want to mount into harder surfaces like cement,

concrete, or brick, you will want to pre-drill holes.

Use the included mounting bracket and (2) screws to mount the Dual Head LED Security Spotlight securely

to a wall.

TO INSTALL THE MOUNTING BRACKET:

1. Remove the mounting bracket from the back of the light by unscrewing the (one)

thumb screw and pushing the button at the top of the base of the back of the light.

2. Hold the mounting bracket up to the wall where you want to mount it.

3. Use a drill to drill through the mounting bracket and into the wall for one of the holes.

Drill in the center of the protruding oval sections.

4. After one hole is drilled fully through the mounting bracket and into the wall,

LOOSELY install a screw through both. If a wall anchor is needed, use a slightly

larger drill bit to widen the hole in the wall ONLY to accommodate the wall anchor.

Then LOOSELY install the screw through the bracket and into the wall.

5. Rotate the mounting bracket around the installed screw until the mounting bracket is

level. Then drill through the other protruding area on the bracket and into the wall.

Repeat the steps to install the wall anchor if needed, then install a screw through

this hole as well.

6. Tighten both screws and slide the light over the mounting bracket until the button on

top clicks into place. Then replace the thumb screw in the bottom of the light and

mounting bracket.

Drill one hole on

this raised area

Drill one hole on

this raised area