Installation Manual

4
OPERATING YOUR DUAL HEAD LED SECURITY SPOTLIGHT
On the back of the motion sensor, there are 3 adjustment dials: TIME,
SENS, and LUX
The Dual Head LED Security Spotlight has been factory preset as follows:
TIME - Set at 15 seconds.
SENS – Set at a 10 - 15 foot range (when the surrounding temperature
is 75 F).
LUX - Set for your Security Light to activate at dusk when motion is
detected.
If the above settings are not suitable for your application, then these may be adjusted by spinning the motion
sensor around so you have access to the dials on the backside.
TIME PERIOD ADJUSTMENT
The time period control dial sets the duration that the Dual Head LED Security Spotlight will remain illuminated
after the last detected motion. The time period has an adjustable range of 10 seconds to 30 seconds.
To decrease the time period, move the dial toward the ( – ) symbol.
To increase the time period, move the dial toward the ( + ) symbol.
Test the time period by triggering the motion sensor and measure the time period the light stays on. Adjust
the TIME control until the desired illumination duration is reached.
A shorter TIME setting will conserve battery life. For best results, use the shortest TIME setting for your
location as possible.
MOTION SENSOR RANGE ADJUSTMENT
The motion sensor on Dual Head LED Security Spotlight is temperature-sensitive. The cooler the
temperature, the more sensitive the motion sensor will become. Use the SENS dial to adjust the sensitivity
of the motion sensor to compensate for environmental temperature changes. The motion sensor is most
sensitive when the SENS dial is turned fully clockwise (+).
To decrease sensitivity, move the dial toward the ( – ) symbol.
To increase sensitivit
y, move the dial toward the ( + ) symbol.
To test the motion sensitivity, aim the sensor head toward the desired area. Set the TIME dial to minimum
( – ) position and the LUX dial to maximum (+). Walk slowly around the area of detection, changing your
walking pace until the Dual Head LED Security Spotlight comes on. If light does not come on, you may need
to adjust the direction of the sensor unit. Make adjustments as needed until the desired level of sensitivity is
reached. Re-adjust the TIME and SENS dials when complete.
LIGHT LEVEL ADJUSTMENT
The LUX dial controls the natural light level that triggers the Dual Head LED Security Spotlight and prevents
it from operating during daylight hours. Your Dual Head LED Security Spotlight comes preset for activation
at dusk.
To adjust for activation before dusk, move the dial toward maximum (+).
To adjust for activation after dusk, move the dial toward minimum (-).
RETURN ADJUSTMENT DIALS TO THE BACKSIDE
front. Adjustment dials should be on the backside of the motion sensor during every day use.
After installing new batteries in your Dual Head LED Security Spotlight, move the switch on the main body
to the AUTO position. When you do this, the light should activate immediately, regardless of lighting
conditions or motion. This is a test activation to show there is power flowing from the batteries to the light.
It should last roughly 30 seconds. After this test activation, the light will function based on the dial settings
mentioned below. Your Dual Head LED Security Spotlight is now ready for use.