Installation Manual

5
TROUBLESHOOTING:
PROBLEM POSSIBLE SOLUTIONS
Dual Head LED
Security Spotlight will
not switch on when
there is movement in
the detection area.
• Ensure that the power button on the main body is in the AUTO position.
• Ensure that the Dual Head LED Security Spotlight has been positioned so
the motion sensor faces oncoming movement.
• Ensure that the batteries have enough charge.
• Check to see that the LUX control has not been set too far towards the
minimum (-). Setting the LUX control too far towards minimum (-) will cause
the Dual Head LED Security Spotlight to turn on only in complete darkness.
• Check to see that the motion sensor is not near night time light sources such
as street lights.
Light switches on
during the day
• The LUX control may be set too far towards the maximum (+) position.
• Reposition the Dual Head LED Security Spotlight so the motion sensor faces
a different direction.
Light switches on for
no apparent reason
•
This may be unavoidable; however the sensor could be redirected to a spot
where this is less likely to occur.
•
or white walls, you may need to redirect or possibly reposition the motion
sensor.
• Test the motion sensor by covering it completely with cardboard and waiting
several minutes to make sure it does not detect motion. If the Dual Head
LED Security Spotlight still switches on, please contact MAXSA for further
assistance.
on and off.
• Battery charge may be low. See “Replacing the Batteries” on Pg 2
• Move the LUX control more towards the minimum (-) position..
Light is not as bright
as normal
• Battery charge may be low. See “Replacing the Batteries” on Pg 2