User's Manual

MaxStream, Inc. 24XStream Wireless Module Manual v2.8
22
24XStream Command Table
AT Command Binary Command #
Description Parameters
# Bytes Returned Factory Default
DT 0
V4.08
Set the Module Address. (Only
modules with the same address can
communicate.)
Address value
Range: 0 – FFFFH
2 0
SM 1 Adjust Sleep Mode setting. 0 – No Sleep Mode
1 – Pin Sleep
2 – Serial Port Sleep
3 – Cyclic 0.5 second sleep
4 – Cyclic 1.0 second sleep
5 – Cyclic 2.0 second sleep
6 – Cyclic 4.0 second sleep
7 – Cyclic 8.0 second sleep
1 0
ST 2 Set time to sleep. Time of
inactivity before entering Sleep
Mode (This number is only valid
in Cyclic and Serial Port Sleep
settings).
Number of tenths of seconds.
Range: 0 – FFFFH.
2 64
HT 3 Set time before long header. Time
of inactivity before a long header
is used.
Number of tenths of seconds.
Range: 0 – FFFFH.
(65535 means no long header)
2 FF
FF
BT 4 Set silence time before command
sequence.
Number of tenths of seconds.
Range: 0 – FFFFH.
2 A
AT 5 Set silence time after command
sequence
Number of tenths of seconds
Range: 0 – FFFFH.
2 A
CT 6 Set time out from AT command
mode. Returns to Idle Mode from
AT mode if no valid commands
have been received within this
time period.
Number of tenths of seconds.
Range: 0 – FFFFH.
2 C8
FL 7 Set serial software flow control.
(Hardware flow control (*CTS) is
always on.)
0- no software flow control
1- use software flow control
1 0
WR 8 Write all configurable parameters
to non-volatile memory. All
settable parameters are stored.
NA NA NA
CN 9 Exit AT command mode. NA NA NA
E0 10 No echo in AT command mode. NA NA NA
E1 11 Echo characters in AT command
mode.
NA NA NA