User's Manual

Table Of Contents

9XCite Wireless OEM Module – Product Manual v1.0

Module Configuration

The following versions of the 9XCite Module are currently available:

• 900 MHz, 9600 (over-the-air) Baud, Hopping Channel Mode

• 900 MHz, 9600 Baud, Single Channel mode

• 900 MHz, 38400 Baud, Hopping Channel mode

• 900 MHz, 38400 Baud, Single Channel mode

9XCite Modules can operate in both Single Channel and Hopping

modes. Mode is selectable using the “Function Set” dropdown list of

the “XCite Configuration” tab of the MaxStream-provided XCite-CTU Software.

For More Information

Go to the "XCite Advanced

Programming & Configuration"

Manual for more detailed

information about

module configurations.

The advanced manual is available

on the MaxStream CD

or on the web:

www.MaxStream.net)

The 9XCite Module is shipped with a unique parameter set in its memory. Parameters within the

set are organized under the following three categories: AT Commands, Non-AT Settable

Parameters and Read-Only AT Commands.

Command & Parameter Types

AT Commands

AT Commands can be changed at any time by entering AT Command Mode and sending

commands to the module.

AT Commands can be modified using the any of the following means:

• XCite-CTU Software

• Serial Communications Software (“HyperTerminal”, “Pro Comm”, etc.)

• Microcontroller

Non-AT Settable Parameters (XCite-CTU Software configurable only)

Non-AT Settable Parameters can only be adjusted using the MaxStream-provided XCite-CTU

Software. To modify Non-AT Settable Parameter, connect the module to the serial com port of a

PC (interface board is necessary for RS-232 connection) and modify parameter values through

the XCite-CTU Software interface. These parameters enable features that need to be set before

the module is used in the field. [Non-AT Settable Parameters are listed in table 7.]

Non-AT Settable Parameters can be modified using the following means:

• XCite-CTU Software (MaxStream-provided)