User's Manual

Table Of Contents

9XCite Wireless OEM Module – Product Manual v1.0

FCC Notice

Compliance to the following is also required:

IMPORTANT: The 9XCite (900 MHz) OEM Module has been certified by the FCC for use

with other products without any further certification (as per FCC section

2.1091). Changes or modifications not expressly approved by

MaxStream could void the user’s authority to operate the equipment.

IMPORTANT: OEMs must test their final product to comply with unintentional radiators

(FCC section 15.107 and 15.109) before declaring compliance of their

final product to Part 15 of the FCC Rules.

IMPORTANT: The 9XCite wireless OEM module has been certified for mobile and base

station applications. If the 9XCite will be used for portable applications,

the device must undergo SAR testing.

NOTE:

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment

off and on, the user is encouraged to try to correct the interference by one or more of the

following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver

is connected.

• Consult the dealer or an experience radio/TV technician for help.