User's Manual

Table Of Contents

9XCite Wireless OEM Module – Product Manual v1.0

9XCite (900 MHz) Approved Antenna List

ANTENNA WARNING

WARNING This device has been tested with Reverse Polarity SMA connectors with the antennas listed in Table A1

[next page]. When integrated into the OEM product, these fixed antennas require installation preventing

end-users from replacing them with non-approved antennas. Any antenna not already tested with the

9XCite module must be tested to comply with FCC Section 15.203 for unique antenna connectors and

Section 15.247 for emissions.

Table A1. Antennas approved for use with the 9XCite Wireless OEM Module.

Part Number Type Gain Application

* Yagi 6.2dBi Fixed/Mobile

* Yagi 7.2dBi Fixed/Mobile

A09-Y8 Yagi 8.2dBi Fixed/Mobile

Yagi 9.2dBi Fixed/Mobile

Yagi 10.2dBi Fixed/Mobile

A09-Y11 Yagi 11.2dBi Fixed/Mobile

Yagi 12.2dBi Fixed/Mobile

Yagi 13.2dBi Fixed/Mobile

Yagi 14.2dBi Fixed/Mobile

A09-Y15 Yagi 15.2dBi Fixed/Mobile

A09-F2 Omni Direct. 2.2dBi Fixed

A09-F5 Omni Direct. 5.2dBi Fixed

A09-F8 Omni Direct. 8.2dBi Fixed

* Omni Direct. 9.2dBi Fixed

* Omni Direct. 7.2dBi Fixed

A09-M7 Omni Direct. 7.2dBi Fixed

A09-H 1/2 wave antenna 2.1dBi Fixed/Mobile

A09-HBMM-P5I 1/2 wave antenna 2.1dBi Fixed/Mobile

A09-QBMM-P5I 1/4 wave antenna 1.9 dBi Fixed/Mobile

1/4 wave integrated wire

antenna

1.9 dBi Fixed/Mobile

* FCC-approved antennas not inventoried by MaxStream – Contact MaxStream for more information.

In addition to the antennas listed in Table A1, over 100 additional antennas have been tested and

approved for use with the 9XCite module. Contact MaxStream toll-free (1-866-765-9885) for a

complete list that includes “Mag Mount”, “Dome”, “Multi-path” and “Panel” antennas.

RF EXPOSURE

WARNING The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20

cm from all persons and must not be co-located or operating in conjunction with any other antenna or

transmitter for satisfying RF exposure compliance.

The preceding statement must be included as a CAUTION statement in manuals for OEM products to alert

users on FCC RF Exposure compliance.