User's Manual

MaxStream 9XStream™ Wireless OEM Module Manual v2.8
39
Confidential and Proprietary, ©MaxStream, Inc. 2001
Appendix E – 9XStream Commands
AT Command Binary Command Number
Version
Description Parameters
# Bytes Returned Factory Default
DT 0 4.08 Set the Module Address. (Only
modules with the same address can
communicate.)
Range: 0 – FFFFH 2 0
SM 1 4.08 Adjust Sleep Mode Setting 0 - No Sleep
1 – Pin Sleep
2 – Serial Port Sleep
3 – Cyclic 0.5 second
4 – Cyclic 1.0 second
5 – Cyclic 2.0 second
6 – Cyclic 4.0 second
7 – Cyclic 8.0 second
1 0
ST 2 4.08 Set time to Sleep. Time of
inactivity before entering Sleep
Mode (This number is only valid
in Cyclic and Serial Port Sleep
settings).
Range: 10 – FFFFH
(tenths of a second)
2 64H
HT 3 4.08 Set time before long header. Time
of inactivity (no serial or over-the-
air data is transmitted or received)
before a long header is used. The
default value (FFFFH) means no
long header will be sent.
Range: 0 – FFFFH
(tenths of a second)
2 FFFFH
BT 4 4.08 Set silence time before command
sequence.
Range: 0 – FFFFH
(tenths of a second)
2 AH
AT 5 4.08 Set silence time after command
sequence.
Range: 0 – FFFFH
(tenths of a second)
2 AH
CT 6 4.08 Set time out from AT Command
Mode. Returns to Idle Mode from
AT Command Mode if no valid
commands have been received
within this time period.
Range: 0 – FFFFH
(tenths of a second)
2 C8H
FL 7 4.08 Set serial software flow control.
(Hardware flow control (CTS) is
always on.)
1- No software flow
control
1- use software
flow control
1 0
WR 8 4.08 Write all configurable parameters
to non-volatile memory. All
settable parameters are stored.
NA NA NA