User's Manual

MaxStream 9XStream™ Wireless OEM Module Manual v2.8
40
Confidential and Proprietary, ©MaxStream, Inc. 2001
Appendix E – 9XStream Commands (cont.)
AT Command Binary Command Number
Version
Description Parameters
# Bytes Returned Factory Default
CN 9 4.08 Exit AT Command Mode. NA NA NA
E1 11 4.08 Enable character echo in AT
command mode.
NA NA NA
LH
12 4.08 Transmit header time. Used to
adjust the length of the long
header.
Range: 0 – FFH
(tenths of a second)
1 1H
FH 13 4.08 Force header on next transmit. NA NA NA
RE 14 4.08 Restore defaults configuration. NA NA NA
ER 15 4.08 Set Receive Error Count. This
value is reset to 0 after every reset.
It is not non-volatile. Once this
counter reaches FFFFH, it remains
there until reset.
Range: 0 – FFFFH 2 0
GD 16 4.08 Set Receive Good Count. This
value is reset to 0 after every reset.
It is not non-volatile. Once this
counter reaches FFFFH, it remains
there until reset.
Range: 0 – FFFFH 2 0
HP 17 4.08 Set Network number. Each
Network uses a different hop
sequence. Seven different
Network numbers are available.
This can be used to operate
independent networks of 9XStream
modules in the same vicinity.
Range: 0 – 6 1 0
MK 18 4.08 Set Module Address Mask. Only
bits set to ‘1’ are used in the
address comparison between the
transmitter’s address and that of
the receiver. A global address is
an address that has the same bits
set as the Address Mask.
Range: 0 – FFFFH 2 FFFFH
CC 19 4.08 Set command sequence character.
The parameters determine the
ASCII command sequence
character used to enter AT
Command Mode.
Range: 20H – 7FH 1 2BH
(‘+’)