User's Manual

MaxStream 9XStream™ Wireless OEM Module Manual v2.8
52
Confidential and Proprietary, ©MaxStream, Inc. 2001
Instructions:
1. Assemble and Connect Interface Boards to computers.
a.
Connect the modules to the Interface Boards by fitting the 4 and 11-pin
connectors into their respective female headers.
b.
Attach the male sides of one of the DB-9 Connecting Cables to the
female DB-9 jacks on the Interface Boards.
c.
Attach the female side of a DB-9 connecting cable to an available RS-
232 port on the back of Computer 1. Connect Module 2 to Computer 2
in the same fashion.
d.
Plug power supplies into the Interface Boards. Turn the switch on. The
red LEDs on the Interface Boards will illuminate to show the boards
are powered.
e.
Refer to figure 1 for completed assembly.
2. Run and configure HyperTrm.exe on both computers
a. Open the folder on the Start Menu found under Programs ->
Accessories -> Communications -> HyperTerminal.
b. Double-click on the application HyperTrm.exe and choose a
name and an icon for the new connection in the Connection
Description dialogue box.
c. In the Connect To dialogue box on each computer, select
Connect using: Direct to Com1 or Direct to Com2 to correspond
with the COM port used on the respective computers (see figure
2) . Click OK.
d. In the COM Properties dialogue box, set the following: Bits
per second: 19200; Data bits: 8; Parity: None; Stop Bits: 1 and
Flow Control: Hardware (See figure 3). Click OK. (Set the Bits
per second to 9600 if you are using 9XStream-96 modules)
e. Both computers are now set up and ready to communicate.
Figure 2 –Connect To Dialogue
Box