User's Manual

9XTend™ OEM RF Module - Product Manual v2.x6x
© 2010 MaxStream, Inc. 5
Specifications
* If the supply voltage for a given power se ing is lower than the minimum supply voltage requirement (as shown in Table 1-02), the
TX Power Output will decrease to the highest power level se
ing given the current supply voltage.
** 1W Power Output is not supported when using a 3.3 supply voltage.
Table 1-01. 9XTend-PKG-R OEM RF Module
9XTend 900 MHz OEM RF Module Specifications
Performance @9600 bps Throughput Data Rate @115200 bps Throughput Data Rate
Transmit Power Output
(software selectable using PL command)
ttaW 1 - Wm1ttaW 1 - Wm1
)m 054( ’0051 ot pU)m 009( ’0003 ot pUegnaR nabrU/roodnI
Outdoor
RF line-of-sight Range
Up to 14 miles (22 km) w/ dipole antenna
Up to 40 miles (64 km) w/ high-gain antenna
Up to 7 miles (11 km) w/ dipole antenna
Up to 20 miles (32 km) w/ high-gain antenna
Interface Data Rate
(software selectable using BD command)
spb 00403
2 – 0021spb 004032 – 0021
Throughput Data Rate
(software selectable
using BR command)
spb 002,511spb 006,9
spb 000,521spb 000,01etaR ataD FR
mBd 001-mBd 011-ytiv
itisneS revieceR
Power Requirements
Am 08tnerruC evieceR
lacipyt Aμ 5nwoD rewoP edoM nwodtuhS
Aμ 741nwoD rewoP peelS niP
Idle Currents
Am 8.0 - 3.0)8=MS
( peels cilcyc ces 61
Am 4.1 - 4.0)7=MS( peels cilcyc ces 8
Am 6.2 - 6.0)6=MS( peels cilcyc ces 4
Am 8.
4 - 9.0)5=MS( peels cilcyc ces 2
Am 7.8 - 6.1)4=MS( peels cilcyc ces 1
Networking & Security
Frequency 902-928 MHz
)murtcepS daerpS gnippoH ycneuqerF( SSHFmurtcepS daerpS
)gniyeK tfihS ycneuqerF( KSFnoitaludoM
aler
”evalS/retsaM“( reeP-ot-reePseigolopoT krowteN detroppuS tionship not required), Point-to-Point, Point-to-Multipoint
seicneuqerf 05 erahs secneuqes poh 01yticap
aC lennahC
refeR – noitpyrcnE SEA tib-652noitpyrcnE to the KY Command [p29] to implement
Physical Properties
x ”83.2 x ”44.1eziS draoB eludoM FR 0.20” (3.65 cm x 6.05 cm x 0.51 cm)
Weight 0.64 oz. (18 g)
Connector 20-pin
04-erutarepmeT gnitarepO to 85º C (industrial)
Antenna
XCMM ro )AMS ytiralop-esreveR( AMSPRsnoitpO rotcennoC
decnalabnu smho 05ecnadepmI
Certifications (partial list)
DNETX9-RUO742.51 traP CCF
DNETX9-A4124)CI( adanaC yrtsudnI
Table 1-02. XTend OEM RF Module Speccations - Relative to user-selected TX Power Output
Power Requirements (Supply voltage and TX currents relative to each TX Power Output option)
Transmit Power Output 1 mW 10 mW 100 mW 500 mW * 1 W *
CDV 5.5 - 57.4CDV 5.5 - 0.3CDV 5.5 - 8.2egatloV ylppuS
Transmit Current (5 V) typical 110 mA 140 mA 270 mA 500 mA 730 mA
Transmit Current (3.3 V) typical 90 mA 110 mA 260 mA 600 mA **
*
**
* Throughput is always lower than the RF data rate due to overhead.