User's Manual

9XTend™ OEM RF Module - Product Manual v2.x6x

Example: Utilize the 'Terminal' tab of the X-CTU Software to change the module's DL (Destination

Address Low) parameter and save the new address to non-volatile memory. This example requires

the installation of MaxStream’s X-CTU Software and a serial connection to a PC.

Select the ‘Terminal’ tab of the X-CTU Software and enter the following command lines:

Method 1 (One line per command)

esnopseR metsySdnammoC TA dneS 

)edoM dnammoC TA retnE( >RC< KO+++ 

noitanitseD daeR( >RC< }eu

lav tnerruc{>retnE< LDT

Address Low)

)woL sserddA noitanitseD yfidoM( >RC< KO>retnE< D0A10000LDTA 

)yromem elital

ov-non ot etirW( >RC< KO>retnE< RWTA 

)edoM dnammoC tixE( >RC< KO>retnE< NCTA

Note: When using X-CTU Software to program a module, PC com port settings must match the

baud (interface data rate), parity & stop bits parameter settings of the module. Use the 'Com Port

Setup' section of the "PC Settings" tab to configure PC com port settings to match those of the

module.

AT Command Reference Table

9XTend RF Modules expect numerical values in hexadecimal. Hexadecimal values are designated

by a "0x" prefix. Decimal equivalents are designated by a "d" suffix.

Table 5-01. Special)

Table 5-02. Networking

AT Command AT Command Name Parameter Range

Command