User Manual
Table Of Contents
- 1. Overview
- 2. RF Module Operation
- 3. XBee ZigBee Networks
- Introduction to ZigBee
- ZigBee Stack Layers
- Networking Concepts
- ZigBee Application Layers: In Depth
- Coordinator Operation
- Router Operation
- End Device Operation
- Channel Scanning
- 4. Transmission, Addressing, and Routing
- 5. Security
- 6. Network Commissioning and Diagnostics
- 7. Managing End Devices
- 8. XBee Analog and Digital IO Lines
- 9. API Operation
- API Frame Specifications
- API UART Exchanges
- Supporting the API
- API Frames
- AT Command
- AT Command - Queue Parameter Value
- ZigBee Transmit Request
- Explicit Addressing ZigBee Command Frame
- Remote AT Command Request
- Create Source Route
- AT Command Response
- Modem Status
- ZigBee Transmit Status
- ZigBee Receive Packet
- ZigBee Explicit Rx Indicator
- ZigBee IO Data Sample Rx Indicator
- XBee Sensor Read Indicator
- Node Identification Indicator
- Remote Command Response
- Over-the-Air Firmware Update Status
- Route Record Indicator
- Many-to-One Route Request Indicator
- Sending ZigBee Device Objects (ZDO) Commands with the API
- Sending ZigBee Cluster Library (ZCL) Commands with the API
- Sending Public Profile Commands with the API
- 10. XBee Command Reference Tables
- 11. Module Support
- Appendix A: Definitions
- Appendix B: Agency Certifications
- Appendix C: Migrating from ZNet 2.5 to XBee ZB
- Appendix D: Additional Information
XBee®/XBee‐PRO®ZBRFModules
©2011DigiInternational,Inc. 10
Hardware Specs for Programmable Variant
The following specifications need to be added to the current measurement of the previous table if the module
has the programmable secondary processor. For example, if the secondary processor is running and
constantly collecting DIO samples at a rate while having the RF portion of the XBEE sleeping the new current
will be I
total
= I
r2
+ I
0
, where I
r2
is the runtime current of the secondary processor and I
s
is the sleep current
of the RF portion of the module of the XBEE-PRO (S2B) listed in the table below.
Mechanical Drawings
MechanicaldrawingsoftheXBee®/XBee‐PRO®ZBRFModules(antennaoptionsnotshown)
.
Australia C-Tick C-Tick C-Tick
Japan R201WW07215215
R201WW08215142 (international
variant)
R201WW10215062 (international variant)
RoHS Compliant Compliant Compliant
Specificationsoftheprogrammablesecondaryprocessor
Optional Secondary Processor Specification
These numbers add to S2B specifications
(Add to RX, TX, and sleep currents depending on
mode of operation)
Runtime current for 32k running at 20MHz +14mA
Runtime current for 32k running at 1MHz +1mA
Sleep current +0.5uA typical
For additional specifications see Freescale Datasheet and
Manual
MC9S08QE32
Minimum Reset low pulse time for EM250 +50 nS (additional resistor increases minimum time)
VREF Range 1.8VDC to VCC
SpecificationsoftheXBee®/XBee‐PRO®ZBRFModule
Specification XBee XBee-PRO (S2) XBee-PRO (S2B)