Modem User's Manual

1. Make sure the correct modem type is selected in the Voice/

FAX software. Use “Cirrus Logic” or similar selection. Do

not select “Rockwell or Rockwell ICS” configuration.

Section Seven - Specifications

CCITT/Bell Std. V.42bis, V.42, V.32bis, V.32, V.29,

V.27ter, V.22bis, V.22, V.21, V.17,

Bell212/103

MNP protocols: MNP 5, 4, 3, 2

Host Interface: 8 bit PC bus

COM ports: 1, 2, 3, 4

IRQ lines: 2, 3, 4, 5

FAX Group: Group III Send/Receive Standard

FAX Command set: EIA/TIA-578 Service Class 1

Voice Command set: Cirrus Logic

Escape Detection: TIES Escape Sequence

Transmit level: -12 dBm +/- 1 dB

Receiver Sensitivity: -40 dBm

UART: 16550 compatible

Data format: 300-57600 bps (8N1, 7E1,7E2,7O1,7O2)

Power: 0.75 W

Temperature: 0 to 55 degrees C (Operating); -20 to 80

degrees C (Non-operating)

Section Eight - Support and Service

In the unlikely event you experience difficulty in the use of this

product, we suggest you: (1) consult the Troubleshooting section

of this guide and (2) consult with your dealer. To obtain service for

this product, follow the Return Merchandise Authorization Proce-

dure as outlined in the Warranty card.

Section Nine - FCC , DOC & Other Notices

9.1 FCC Compliance

This equipment complies with Part 68 of the FCC Rules. On this

equipment is a label that contains, among other information, the

FCC registration number and Ringer Equivalence Number (REN)

for this equipment. You must, upon request, provide this informa-

tion to your telephone company.

If your telephone equipment causes harm to the telephone net-

work, the Telephone Company may discontinue your service

temporarily. If possible, they will notify in advance. But, if

advance notice isn’t practical, you will be notified as soon as