Modem User's Manual

10
\Bn n=1-9 Send a 1/10 second line break to the modem,
where n = 1 to 9. At normal connect, the
default is 3
\C_ \C0 Do not buffer data during LAPM/MNP
handshaking
\C1 Buffer all data for 4 seconds, until receiving
200 characters or until a packet is detected
\C2 Do not buffer data; switch to normal mode
when fallback character is detected
\G_ \G0 Disable DCE flow control
\G1 Enable DCE flow control
\J_ J0 Disable serial port data rate adjustment
(keep high data rate between DTE and
modem, regardless of modem-to-modem
data rate)
J1 Enable serial port data rate adjustment so
serial data rate automatically adjusts to match
the modem-to-modem data rate
\Kn n=0-5 Set break control, where n= 0 to 5. Default
is 5
\N_ \N0 Normal data-link only
\N1 Direct data-link only
\N2 MNP data link only
\N3 V.42/MNP/Normal data link
\N4 V.42 data link only
\O Initiate reliable link during a normal link
\Q_ \Q0 Turn off flow control
\Q1 XON/XOFF software flow control
\Q2 CTS signal unidirectional hardware flow
control
\Q3 RTS/CTS signal bi-directional hardware
flow control
\Tn Inactivity timer, where n = 0 to 90 minutes.
Default is 0
\U Accept reliable link during a normal link
\V_ \V0 Do not send extended responses
\V1 Send extended response set 1
\V2 Send extended response set 2
\X_ \X0 Process XON/XOFF but don’t pass through
\X1 Process XON/XOFF and pass through