User guide

8
After Sales Support
UK/N.IRELAND HELPLINE N
O
:
REP.IRELAND HELPLINE N
O
:
WEBSITE:
EMAIL:
01270 508538
1800 995 036
www.quesh.co.uk
[e-mail]
Radio Operation
Choose Radio Band
Press the BND Button anytime to access the radio
function. The unit comes with five bands, three FM
Bands (FM1, FM2, and FM3) and two AM Bands
(AM1, and AM2). Each of the five bands can store
up to six preset stations, for a total of 30 preset
memory stations.
Radio Tune / Seek Function
In radio mode, press the Seek +/- button to
automatically seek the next strong and clear radio
station. Press and hold the Seek +/- button until
the screen shows MANUAL. At this time, you can
manually fine tune your desired frequency. Wait until
the MANUAL disappears in order to perform auto
seek again.
Press and hold the SEEK |<< or >>| button for 2
seconds and the radio will seek the next strong
and clear frequency station. Repeat to seek more
stations in your listening area with a strong signal.
Mono / Stereo Reception Control
In FM radio mode, Press VOL button repeatedly
until the display shows ‘MONO’ or “STEREO”.
Rotate the VOL dial to choose the reception control,
the word “MONO” shown on the screen indicating
the mono reception is received and “STEREO” for
stereo.
Save Your Preset Stations
There are six numbered preset buttons which
can store and recall stations for each band. While
listening to a radio station you would like to save
as a pre-set, press and hold one of the buttons
numbered 1-6 until the preset station number is
shown. The button you pressed is now the pre-set
button for that station.
Automatic Scan & Store
While listening to the FM or AM Radio, press and
hold the F/PS Button for 3 seconds. The receiver
will automatically scan and save to the presets the
strongest radio station signals available to you in
your area.
Scan Saved Stations
Press the F/PS button once to perform the preset
scanning function. In FM or AM mode, press the F/
PS button and the stations stored in the FM band
preset will be scanned. The scan will pause on each
preset for 6 seconds before moving on to the next.
To stop and listen to a preset of your choice press
the SEL dial.
Local / DX
Press VOL Button repeatedly until the display shown
“LOC”. Rotate the VOL button to choose,
“LOC ON“ or “LOC OFF”. When “LOC ON” is shown
on the display, this means local reception is turned
on. When “LOC OFF” is shown on the display, this
means distant reception is turned on.
Local and distance reception settings can facilitate
the radio reception, depending on the location in
which the radio is being used.