User`s manual

Network Stand Alone DVR

Network (JPEG2000+H.264)

•Key Release for PTZ function

power on , light on "1"

power off , light off "2"

iris open "3"

iris close "4"

focus near "5"

focus far "6"

zoom in "7"

zoom out "8"

set preset "9"

clear preset "0"

goto preset "!"

auto scan "@"

tilt up "u"

tilt down "j"

pan left "h"

pan right "k"

"&Z"

•To stop transmitting the signal to DVRs via RS232

1) Set preset

"T“ → “U, "J", "H", "K" (To move where you want to see) → "9"( set preset ) → "&Z" →

"&+",&-" (To set other preset point)

2) Clear preset

"T“ → "0" → "&Z" → "&+","&-" (To choose which you want to delete ) → "enter"

3) Goto preset

"T" → "!“ → "&Z" → "&+","&-" ( To choose where you want to see ) → "enter"

※ Reference

1.Funtions where the OSD [xx] to the right of the function is not seen pressing "1" or "2" will bring

it up.

2.Operations such as 'clear preset' take affect upon pressing the ‘0’ key causing the last preset to

be deleted even though that may not be the desired action. Instead use the next key 'N' until 'clear

preset' is up then choose the preset to be deleted followed by enter.

3.For units lacking a front panel jog shuttle the '15/F3' and '16/F4' ASCII front panel equivalent can

be used.

CHAP. 9 Programmer reference