Instruction manual
8 8921ADT Instruction Manual
Installation
Installation
Installation of the 8921ADT module is a process of:
1.
Setting on-board jumpers for desired output formats,
2.
Placing the module in the proper audio frame slot, and
3.
Cabling and terminating signal ports.
The 8921ADT module can be plugged in and removed from a Gecko 8900
audio frame with power on. When power is applied to the module, LED
indicators reflect the initialization process (see
Power Up
on page 14).
Module On-board Jumper Settings
A number of jumpers must be set on the module to determine module for-
matting before installing it in the frame. Refer to Table 1 for a summary of
each jumper and Figure 1 on page 9 for jumper locations on the module
circuit board.
Table 1. 8921ADT Jumper Settings
Jumper Function Pins 1-2 Pins 2-3 Notes
J2 AES 1&2 Out 1
BAL
(Balanced
110
Ω
)
UN
(Unbalanced
75
Ω
) Set AES outputs to balanced or unbalanced (unbalanced setting requires
cable adapter).
J3 AES 1&2 Out 2 BAL UN
J4 AES 1&2 Out 3 BAL UN
J5 BNC J11 AES 1 TRK IN Assign BNC function as Tracking In or AES 1 output (unbalanced)
J6 BNC J12 AES 2 TRK OUT Assign BNC function as Tracking Out or AES 2 output (unbalanced)
J11 Local/Remote LOCAL REMOTE
Move jumper to Local to lock out remote control if desired. Shipped
from factory with Remote setting.
J12 Sample Rate – 48 kHZ Sample rate default is set to 48 KHz for this release.
J13 AES 1 Output Resolution 20 BITS 24 BITS
Set output resolution for AES outputs. These settings can be overridden
remotely on the Audio Proc web page or with a control panel.
J14 AES 2 Output Resolution 20 BITS 24 BITS