Product manual

Index
I-2 Maxtor Atlas 10K IV
disks 4-1
DOS 4-3
Drive Step Rate 5-68
drop 4-10
E
ECC 5-12, 5-15, 5-43, 5-46, 5-99, 5-
142
encoding method 4-2
Ending Boundary 5-51
environmental conditions 4-8
error correction method 4-2
Error Reporting 5-7
error type 4-11
ESD 3-4
Extent List Length 5-124
F
faceplate 3-3
Field Pointer Bytes 5-122
Firmware Revision 5-27
Firmware Revision Page 5-27
Flag Bit 5-6, 5-13
Format Device 5-65, 5-66
Format Device Page 5-65
FORMAT UNIT Command 5-15, 5-16,
5-17, 5-21
formatted capacity 4-1, 4-3
full stroke 4-4
G
general 2-1
GList 5-95, 5-96, 5-97, 5-98
Grown Defect List 5-15, 5-17, 5-18, 5-
43, 5-95, 5-96, 5-97, 5-98, 5-100
H
hard reset time 4-4
HARDWARE ERROR 5-112
hardware options 3-6
hardware requirements 2-4
Head Offset Count 5-43
host system 3-7
hot plugging 6-11
humidity 4-8
I
idle 4-6
Immed 5-15, 5-18, 5-133, 5-134
Implemented Operating Definition 5-25,
5-26
Implemented Operating Definition Page
5-25, 5-26
Initialization Pattern Descriptor 5-19
input power connections 3-21
inside zone 4-1
interface connector 3-15
Interleave 5-66
J
J1 12-pin Auxiliary Connector 3-22
Jumper Configurations and Connections
(16-bit Drives)
3-6
jumpers 3-7
K
key features 2-1
L
Landing Zone Cylinder 5-68
Link Bit 5-6, 5-13
Log Pages 5-33
LOG SELECT Command 5-32
LOG SENSE Command 5-33, 5-34
Logical Block Address 5-40, 5-51, 5-89,
5-90, 5-93, 5-99, 5-100, 5-110, 5-
112, 5-127, 5-128, 5-129, 5-134,
5-136, 5-137, 5-138, 5-139, 5-142
low 4-3
low-level format 4-3