Product manual

General Description
Maxtor DiamondMax Plus8 20/30/40GB AT 2-3
Versatility
• Power saving modes
• Downloadable firmware
• Cable select feature
• Ability to daisy-chain two drives on the interface
2.3 REGULATORY COMPLIANCE STANDARDS
Maxtor Corporation’s disk drive products meet all domestic and international product
safety regulatory compliance requirements. Maxtor’s disk drive products conform to
the following specifically marked Product Safety Standards:
• Underwriters Laboratories (UL) Standard 1950. This certificate is a
category certification pertaining to all 3.5-inch series drives models.
• Canadian Standards Association (CSA) Standard C.22.2 No. 1950. This
certificate is a category certification pertaining to all 3.5-inch series
drives models.
• TUV Rheinland Standard EN60 950. This certificate is a category
certification pertaining to all 3.5-inch series drives models.
Product EMI/EMS Qualifications:
• CE Mark authorization is granted by TUV Rheinland in compliance
with our qualifying under EN 55022:1994 and EN 50082-1:1997.
• C-Tick Mark is an Australian authorization marked noted on Maxtor’s
disk drive products. The mark proves conformity to the regulatory
compliance document AS/NZS 3548: 1995 and BS EN 55022: 1995.
• Maxtor’s disk drives are designed as a separate subassembly that conforms to the
FCC Rules for Radiated and Conducted emissions, Part 15 Subpart J; Class B
when installed in a given computer system.
• Approval from Taiwan BSMI. Number: 3892A638
2.4 HARDWARE REQUIREMENTS
The Maxtor DiamondMax Plus 8 hard disk drives are compatible with the IBM PC
AT, and other computers that are compatible with the IBM PC AT. It connects to
the PC either by means of a third-party IDE-compatible adapter board, or by plugging
a cable from the drive directly into a PC motherboard that supplies an ATA interface.