User's Manual

3-6
Configuration
8. Termination
Terminating a SCSI chain is achieved by adding a terminator to
each end of the SCSI bus. The Disk Array supports active
termination at the controller's SCSI end.
Termination "enabled" must be set when the Disk Array is at
one end of the SCSI Bus.
9. Set Password
Press " Enter " to activate the Password setting. When the cursor
stop on the desired "number" or "character", Using " " and
" " function keys to choose the desired characters and then
press " Enter " to confirm it.
Press " ESC " function key for password "No Change"
10. Save Configuration & Restart
Select the Save Configuration function and Press the " Enter " key
to save and activate your selections.
Warning ! All data will be lost if you change RAID Levels .
Saving configuration changes causes the disk array
controller's working parameters to change. This can
produce unpredictable results if it occurs during Host
and Array activity. All activity to the controller should
be stopped before saving configuration changes.
WARNING
STOP
STOP