User manual

Maxtronic Orion 410SR User Guide
3
Components of the Orion 410SR
Components of the Orion 410SR
Front View
Back View
Important Notice
Follow the procedures below carefully to initialize your Orion 410SR
NAS System:
1. Connect the power cord and LAN cable.
2. Remove the HDD caddy(s) from the system.
3. Power on the system.
4. Hot plug the HDD caddy(s) into the system. Please make sure the
‘HDDx added OK’ displays on the LCD screen then continue the
next drive installation till the whole process is done.
5. Start configuration through the front control panel or the
browser interface.
Refer to the “Hard Disk Drive Installation” on page 7 section in
Chapter 2 for detailed information.
Power
LED indicator
Control buttons
LCD screen
HDD caddy (x4)
HDD caddy Lock (x4)
ESCEnter
Power P/S Fail Access
Front Panel Lock
UPS
Connector
System
Fan
Power Supply
LAN
Connector
Three-pin power
connector
Power Switch