Specifications

Chapter 7: Deck Equipment
31
Canvas
1800MX Convertible Top (If Equipped)
Installing the Convertible Top
1. Insert the end eyes of the main bow (A) into the forward deck hinges and secure them with the pins.
2. Insert the end eyes of the aft braces (B) into the aft deck hinges and secure them with the pins.
3. Unfold the canvas top and pull the secondary bow (C) and the canvas forward.
4. Open the center windshield panel and stand in the opening.
5. Snap the snaps (D) on each side of the zipper to the first two snaps on the starboard windshield frame.
6. Snap the forward edge canvas snaps to the port and starboard windshield frames.
7. Carefully close the center windshield panel and snap the remaining snaps to the center windshield frame.
8. Align the secondary bow (C) with the center seam of the canvas by loosening or tightening the top straps
(not pictured).
9. No adjustments to the jaw slides (E) should be needed as they are preset during manufacturing. If you decide to
adjust the jaw slide positions, obtain the correct measurements from your selling dealer.
10. If additional canvas (i.e. side curtains or slant back cover) is installed, the canvas top may need readjustment to
align the snaps on the canvas with the snaps on the boat.
PRODUCT or PROPERTY DAMAGE HAZARD!
Take down and securely stow ALL canvas before transporting your boat by road.
CAUTION
!
Two people are needed for most of the tasks listed below and on the following pages in
this section.
NOTICE
B
D
END EYE (TYPICAL)
HINGE (TYPICAL)
SPRING LOADED SECURING PIN (TYPICAL)
A
C
E