Owner`s manual

18
1 Lock the bolt rearward by
pulling the operating handle
fully to the rear.
NOTICE! never Allow the Action
to slAm closed by pressing the
bolt releAse button without the
bArrel instAlled. if the bolt is
releAsed forwArd with
the bArrel removed, the
operAting hAndle will strike the
receiver And cAuse dAmAge.
2 Remove the forearm as
explained previously.
3 Insert the magazine three-shot adapter into the slot in the end of
the magazine tube.
4 Insert a key or flat-blade screwdriver into the slot in the end of the
magazine tube. Press inward and turn the key or screwdriver a
quarter-turn to secure the three-shot adaptor in the magazine
(Figure 12).
5 Reinstall the forearm as explained previously. When the forearm is
in place and the Speed Lock lever is fully locked, the release button
is flush with the surface of the forearm (Figure 8, page 14).
AlwAys ensure the foreArm is fully locked And the speed lock
lever releAse button is flush with the surfAce of the foreArm.
fAilure to follow this wArning could result in serious injury,
deAth or dAmAge to your fireArm.
the key or flat-blade screwdriver a quarter-turn to align the three-
shot adaptor with the slot in the end of the magazine (Figure 10).
This unlocks the three-shot adaptor, allowing it to be removed.
4 If the barrel is on the shotgun, hold it to prevent it from falling out
of the receiver while pointing the magazine tube down to allow the
three-shot adaptor (plug) to fall out of the end of the magazine
tube. Grasp and remove it (Figure 11).
5 Reinstall the forearm as explained previously. When the forearm is
in place and the Speed Lock lever is fully locked, the release button
is flush with the surface of the forearm (Figure 8, page 14).
AlwAys ensure the foreArm is fully locked And the speed lock
lever releAse button is flush with the surfAce of the foreArm.
fAilure to follow this wArning could result in serious injury,
deAth or dAmAge to your fireArm.
INSTALLING THE THREE-SHOT ADAPTOR (PLUG)
If you need to install the magazine three-shot adaptor (plug) to
limit your shotgun magazine to three shells, again perform the
following operation:
figure 12
The three-shot adaptor shown secured in the
magazine tube.
19
figure 10
Use a key or small screwdriver to press in
on the three-shot adaptor, then rotate a
quarter-turn.
figure 11
Remove the three-shot adaptor.
08-121-BFA_Maxus OM.indd 18-19 6/22/09 2:59:57 PM