Product Manual

ENGINE SPEED

Engine speed has been factory set to provide safe operation. Tampering

with the engine speed adjustment could result in the overheating of

attachments and could cause a fire.

CONNECTING LOADS

You will want to be careful when connecting loads so as to not overload the

generator, especially if you are powering devices with motors that require a

higher starting power load.

Instructions are provided below for connecting loads when you are using

the generator as a portable power source.

240V AC CONNECTION

Connect electrical loads one at a time according to the following

instructions:

1. Allow engine to reach operating speed by allowing it to warm up

for approximately 5 minutes before connecting electrical devices.

2. Check the devices to be connected are turned OFF before

connecting them to the AC outlets.

3. After the engine is warmed up, begin by connecting the items that

require the highest wattage first.

The recommended sequence is as follows:

1. Connect items with motors such as refrigerators, freezers, air

conditions or small hand tools, one at a time.

2. Let each motor stabilize before connecting the next device.

3. Connect any lights you are planning on powering.

4. Connect voltage sensitive equipment such as electronics via surge

protectors. Plug devices su

h as TV’s, computers and microwaves

into voltage surge protectors, then plug the surge protector into the

generator.