Product Manual

15
 Pull the handle lock pin and fully raise the handle upright. Release and snap the lock pin into its
locking hole in the frame.
 Assemble the top and bottom gun holders (using the nuts and bolts) to the fame as shown.
Tighten all mounting hardware.
PRESSURE HOSE TO PRESSURE PUMP
Pull back the high-pressure outlet fitting collar. Insert the pressure hose inside the
fitting and release the collar. Tug on the hose to make sure it is secured.
PRESSURE HOSE TO SPRAY GUN
 Pull slip ring on female quick-disconnect fitting of the pressure hose’s
back.
 Insert male quick-disconnecting fitting onto spray gun into the female
quick-disconnect on pressure hose.
 Release slip ring on female quick-disconnect and twist. Listen for “click”
to ensure both quick-disconnects are coupled.
 Pull the pressure hose and spray gun in opposite directions to ensure they
do not separate.
SPRAY WAND TO SPRAY GUN
 Remove the protective plastic cap at the inlet of the wand.
 Thread spray wand onto spray gun.
 Tighten the nut to secure the wand to the gun.