Product Manual
16
SELECTING THE RIGHT NOZZLE FOR THE JOB
The pressure washer comes furnished with five spray nozzles. Each nozzle is colour coded and delivers a
specific spray pattern and pressure for a particular cleaning job. The size of the nozzle determines the
size of the fan spray and the pressure out of the nozzle.
0 Degree Nozzle – RED:
This nozzle delivers as pinpoint stream of pressurised water and is extremely powerful. It covers
only a small area of cleaning. This nozzle should only be directed at surfaces that can withstand
high pressure such as metal or concrete. Do not use this nozzle to clean wood.
15 Degree Nozzle – YELLOW:
This nozzle delivers a power 15 degree spray pattern for intense cleaning of small areas. This
Nozzle should only be used on areas and materials that can withstand high pressure.
25 Degree Nozzle – GREEN:
This nozzle delivers a 25 degree spray pattern for intense cleaning of larger areas. This nozzle
should only be used on areas that can withstand pressure from this nozzle.
40 Degree Nozzle – WHITE:
This nozzle delivers a 40 degree spray pattern and a less powerful stream of water. This
nozzle can cover a wide area and should be used for most general cleaning jobs.
Chemical Nozzle – BLACK:
This nozzle is used to apply special chemicals and cleaning solutions. This nozzle produces the
weakest pressure stream of the five nozzles.
The pressure washer nozzles are stored in receptacles on a panel mounted to the handle
of the washer. Colours on the panel identify nozzle location and spray panel.
NOZZLES TO SPRAY WAND
NEVER place hands in front of the nozzle. Never grasp the hose or fittings during operation. Never
attempt to attach or remove spray wand or hose fittings while the pressure washer system is
pressurised.
TURN OFF the pressure washer and lock the gun trigger before attempting to change pressure nozzles.
To attach, insert the nozzle into the female quick-disconnect spray wand and press
To snap into the nozzle.
To detach, slide down the slip ring on female quick-disconnect to eject the nozzle.
PRESSURE PUMP TO WATER SUPPLY
Connect the garden hose to the water supply and turn water supply on to fill the hose
with water and also remove any debris in the hose. Turn OFF water supply.
Make sure that the filter inside the pressure washer water inlet is clean and
Undamaged. Thread the garden hose fitting into the water hose inlet. Hand tighten the inlet nut.
Turn on water supply.