Product Manual

19
 Place the pressure washer on a flat and level surface and close to the working surface. Keep a
minimum of 5 feet (1.5 meters) clearance on all sides of the engine including the top. Face the
engine exhaust outlet away from dwellings.
 Make sure the throttle lever is set to the fast
position.
 Slide the fuel valve lever to the ON position to allow the fuel to flow to the engine.
 Slide the choke lever to START position.
 Turn the engine ON/OFF switch clockwise
to ON position.
 Point nozzle to safe direction and squeeze the
spray gun trigger to allow for easier engine
start.
 To start the engine, pull the starter cord slowly
Until resistance is felt, then pull rapidly to avoid
The kickback. Repeat until engine starts to run.
 Slide choke lever to RUN position.
OPERATING
DO NOT leave the pressure washer in bypass mode for more than two minutes at a time. The water
temperature inside the pressure pump will rise to a dangerous level resulting in damage to the internal
components of the pump. Failure to follow this warning will void the warranty.
DO NOT run the pressure pump without the water supply connected and turned on. Damage to the
pressure washer resulting from failure to follow this instruction, will void the warranty.
ALWAYS wear approved safety glasses when operating the pressure washer. Spray can splash back
or propel objects, including incorrectly attached accessories.
The high-pressure stream of water that this equipment produces can cut through skin and its
underlying tissues, leading to possible amputation. The spray gun traps high water pressure
even when the motor is stopped and water is disconnected, which can cause injury. Kickback
from the spray gun can cause you to fall.
USING THE SPRAY GUN
To engage the trigger lock, pull the lock up until it clicks into the slot.
To disengage the trigger, push the lock down and into its original position.
TO OPERATE THE TRIGGER:
 Squeeze the trigger to start the water flow through the nozzle.