Product Manual

 Lock the trigger and attach the detergent nozzle (black) to the wand.

 Unlock the trigger and squeeze the spray gun trigger and apply detergent to a dry surface,

starting at a lower portion of area to be washed and work upwards, using long, even and

overlapping strokes.

 Wetting the surface first is not recommended, as it dilutes the detergent and reduces its

cleaning ability.

 Allow detergent to soak in for 3-5 minutes before washing and rinsing. Reapply as needed to

prevent the surface from drying. DO NOT allow detergent to dry on the surface (prevents

streaking).

TO RINSE:

 Replace the nozzle with an appropriate high-pressure nozzle (see Selecting the Right Nozzle).

Squeeze the trigger and wait for the detergent to clear.

 Keep the spray gun a safe distance from the area you plan to spray.

 Apply a high-pressure spray to a small area and then check the surface for damage. If no

damage is found, it is okay to continue cleaning.

 Start at the top of the area to be rinsed, working down with the same overlapping strokes as you

used for washing and applying the detergent.

TO FLUSH THE SYSTEM:

When you have completed the use of the detergent injection system:

 Turn off the engine and fill the detergent tank with clean water.

 Remove the nozzle and then turn the engine back on.

 Point the wand toward a safe direction and squeeze the trigger to flush clean water through the

detergent tank and the system until it is thoroughly clean.

Leaving chemicals and cleaning solutions inside the pressure pump could damage it. Damages created

by leaving soaps, chemicals and cleaning solutions inside the pump will void the warranty.

CLEANING TIPS:

 Never use the pressure washer water inlet to siphon detergent or wax.

 If you have the nozzle too far away from the surface being washed, the cleaning will not be as

effective.

IMPORTANT:

DO NOT get closer than 6 inches when cleaning.

SHUTTING DOWN

 To stop the engine, set the engine switch on the side of the engine to OFF position.

 Slide the fuel valve lever to the left to stop the fuel flowing to the engine.

 Turn off the water supply and disconnect the garden hose from the pressure washer.

 Squeeze the gun trigger to release any remaining water in the system.

 Store the spray gun on the side and hoses inside the hose housing inside the handle.

CAUTION: Allow the engine to cool down before folding the handle.