User's Guide

22
2. The cell-phone will display the “on charging” mark in
closed condition and it will not display in opening condition.
5.6 The signal is on and off
1. Your phone signal will display strong or weak when the net
is unsustainable; you can try it again by changing the district.
2. If all the ways above failed, you should contact with the
sale service center or test in maintenance department.
5.7 Cannot dial out a calling
1. The net signal is weak .please move to the district with
strong signal.
2. It will be busy in net server, try it again after a while.
3. If all the ways above failed, you should contact with the
sale service center or test in maintenance department.
5.8 The shorten standby time
1. The standby time will change by the strong or weak of
the net signal.
2. It will be conditioned by several reasons, such as the
temperature, distance.
1
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
2
CAUTION: Changes or modifications not expressly approved by
the party responsible for compliance could void the user's authority
to operate the equipment.
3
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications.