Installation Manual

REMOTE CONTROL OPERATING GUIDE
WIRELESS REMOTE CONTROL FOR
MAXXFAN
®
Deluxe MODELS 7000K • 7500K
Optional for 8000K, 8500K, 8700K, 8900K Models
FAN ON & POWER OFF - Press this button:
• To start the fan
• To turn the fan o
• To exit Auto Mode
VENT LID POSITION - Press this button to open or close the vent lid
• While the fan is running in Manual Mode press once to close the vent lid and
enter “Ceiling Fan” Mode.
NOTE: This button is not active in Auto Mode. If the fan loses 12volt RV
power or power is removed from the fan, use the knob located at the ceiling
to manually open or close the vent lid if desired.
AIR EXHAUST / INTAKE - Press this button to reverse the fan from
intake or exhaust
NOTE: In Auto Mode, the fan direction is automatically positioned to Exhaust,
but may be overridden and changed to Intake by depressing this key.
FAN AUTO MODE - Press this button to enter Auto Mode
• Auto Mode allows the fan lid to automatically open and the fan motor to
operate as dictated by the thermostat set point temperature. Once the cabin
temperature cools and reaches the set point temperature, the fan lid will close
and the fan motor will shut o.
• Pressing this button while in Auto Mode will shut o Auto Mode, close the vent lid
and shut o the fan motor.
THERMOSTAT SET TEMPERATURE
TEMP + ~ Press this button to increase the Set Temperature for Auto Mode.
TEMP - ~ Press this button to decrease the Set Temperature for Auto Mode.
NOTE: The thermostat temperature range is from 29°F to 99°F or -2°C to 37°C. To change from Fahrenheit
to Celsius on the temperature display, press and hold both set temperature keys simultaneously.
FAN SPEED
Fan Speed + ~ Press
this button to increase
the fan speed. The fan
has ten speeds.
Fan Speed - ~ Press this
button to decrease the
fan speed. The fan has
ten speeds.
NOTE: When the fan
speed reaches either the
maximum or minimum
speed, the fan will
respond with 2 quick
beep sounds to indicate
this.
LOW BATTERY
INDICATOR
• When the battery is at full charge, three black power bars are displayed.
• One or zero power bars displayed indicates the batteries need replacement.
TRANSMISSION SIGNAL
• This symbol is displayed on the screen when any button is pressed to indicate the signal was transmitted
to the fan.
• A beep sound from the ceiling unit indicates the signal from the remote control was received by the fan.
CEILING FAN
SET
TEMPERATURE
TRANSMIT LOW BATTERY
INDICATOR
AIR DIRECTION
INDICATOR
CEILING FAN MODEFAN SPEED
VENT LID
POSITION
FAN OFF
INDICATOR
VENT LID IN
AUTO MODE
FAN ON
INDICATOR
ROOM
TEMPERATURE
AUTO MODE
INDICATOR
Remove protective lm from
Display Screen
8