Use and Care Manual

<2>
VENTAMATIC, LTD. P.O. BOX 728, MINERAL WELLS, TX 76067 • PHONE [phone] • WWW.BVC.COM
A leader in the ventilation industry for over 60 years, Ventamatic, Ltd. offers a complete line of air movement products for
commercial, industrial, agricultural, and residential use.
1 A
1 B
1 C 1 C
FIGURE 1
Maxx Air 20” HIGH VELOCITY FLOOR FAN
ASSEMBLY INSTRUCTIONS
MODEL: HVFF 20
1. Remove two screws from the cradle
arms. Retain screws for use in Step 4 below.
2. Slide one end of U-shaped tube base to
the fan support tube with smaller end
(Fig 1 A in diagram).
3. Slide the other end of the U-shaped
tube base to the second other fan support
tube with smaller end (Fig 1 B in diagram).
4. Align the holes in each side of the tube
base with the holes in each side of the fan
tube. (Fig 1 C in diagram). Secure with
screws removed in Step 1.
1. Use adjustment knobs on either
side of fan to loosen tilt nut by turning
counterclockwise.
2. Adjust fan head to desired tilt.
3. Tighten both knobs by turning
clockwise.
1. Rotate switch to LOW (3), MEDIUM (2) or
HIGH (1) speed for desired air velocity.
PLEASE NOTE:
It is normal for the fan motor to feel warm
to the touch after continuous operation.
This fan features a thermal cuto that will
automatically shut o the motor should it
overheat for any reason. If this happens,
unplug the fan from the outlet immediately.
WARNING: Unplug the fan from electrical
supply before cleaning.
• Use soft, damp cloth to clean fan.
Remove any moisture with clean, dry cloth.
• Do not use any cleaning solution that is
harmful to paint or plastic.
• Do not bend blades when cleaning fan.
TUBE BASE ASSEMBLY INSTRUCTIONS
HOW TO ADJUST TILT
SPEED CONTROL
CLEANING
PLEASE NOTE: The motor bearings in your Maxx Air fan are permanently sealed and DO NOT
REQUIRE additional lubrication.
Your Maxx Air fan requires minimal assembly. Only a Phillips screwdriver is
required to complete the assembly.
If you should have any questions about the operation of your Maxx Air High Velocity Floor Fan, please
contact Ventamatic, Ltd. toll free at 1.800.433.1626